There are many types of the sintered wire mesh, but which type of sintered wire mesh filter can fit your case. When you are purchasing the sintered filter, you should take some points into consideration, like the flow rate, the particle retention, operating fluid. When the fuel filters and hydraulic fluid filters are use in the special industry, like the aerospace, defense, and marine, the filter design should pay more attention to the filter practical use. Here are some points that relate to the usage of the sintered metal filter.

Basically, the sintered wire mesh is a porous panel, which consist of multiple layers of metal meshes. The combination of the sintered wire mesh are quite different, there maybe will be the perforated metal mesh or the woven wire mesh.

Hebei Sinter Filter Technic Co.,Ltd is the professional manufacturer which specializes in producing the stainless steel sinterer wire mesh and other filter elements. We have 4 different types of sintered wire mesh filter, each of them has the different combination of different weave type of wire meshes. And we offer the sintered filter and the filter disc. ​

Sintered wire mesh are consist of more than one layer woven wire mesh. The layers of woven wire mesh will be sintered in the vacuum space. The single layer of the wire mesh will be rolled flattened uniformly, in the meanwhile the experienced will ensure the different layer are contact firmly at the cross over points.

With the special design and the long time improvement, the filter has the stable porous matrix, the precise bubble point, the close thickness tolerances and the uniformity of permeability. All these features makes the filter has the stable filtration performance, effective backwash cleaning and the long life span.

The filter media is a sintered wire mesh that contains 2 or 3 layers of the plain dutch woven wire mesh. The wire meshes were sintered, pressurized and calendered in the vacuum environment. The filter was manufactured based on the wire mesh, thus the filter has the average hole size and the steady a

Sintered wire mesh are consist of multiple layers of wire meshes. The sintering process put the wire meshes under the high heat and pressure in the vacuum environment then it can be sintered solidly. This process can make the sintered wire mesh obtain the excellent mechanical properties. It is the perfect material for the purification and filtration.

The sintered wire mesh is the perfect material for the filter. Due to the sintering process, the five layers can be bond tidely. The solid structure can resist the high speed shock. The opening hole will not deform easily, and the opening ratio can retain the good permeability.

The Type A sintered wire mesh is made from the 5-layer wire mesh. The wire meshes after sintered in the vaccum enviroment will bond tidely. And thus it can form the complete soliod structure. It can be used in many areas.

The Type D sintered wire mesh has 2 or 3 layers of the plain dutch woven wire mesh with the same hole size. The sintered wire mesh will be sintered in the vacuum space, and get pressurized and calendered. The hole size were averagely placed on the metal sheet. The Type D sintered wire mesh can be widely used in powder transport, laboratory fluid bed, driers and coolers.